What did you do in your shed / man cave today?

[rexie1100]

Fixing locks on my shed after some thieving barsteds broke in and stole my,
Drop saw
Cut off saw
Mig welder
Countless cordless tools
Other things are missing, just trying to figure out what.

So far approx. over $2000 and counting.

Oh and the best part, im not insured

[lino6]

Fixing locks on my shed after some thieving barsteds broke in and stole my,
Drop saw
Cut off saw
Mig welder
Countless cordless tools
Other things are missing, just trying to figure out what.

So far approx. over $2000 and counting.

Oh and the best part, im not insured

That sux a lot, here's hoping the pricks loose a hand or something with them.....

[2impulsiv]

That's bad news Rexie!

I moved the CT out and hooked up the solar panel for a few hours. Looked at the water pump I need to set up and said maybe later.....

[RallyDog]

Finally got a chance to replace both fuel filters in the 4by and service the wife's car.

[lino6]

Put my hay mower back together. I had to get some parts made up and now its all back together. Might give it a run tomorrow and see how it goes.

[markg66]

Finally got the 3 way Thetford fridge that was most kindly donated to us by myswagger "JohngQld447" installed today and it's pumping away in the camper beautifully this evening & down to 3 degrees.
Thanks John really appreciate it, working a treat.

Regards
Mark

[Ozsnowman]

Finally cleaned out the dirt & crap in the camper from Easter in preparation for going away again next weekend....

[camperd4d]

Open the tent up and air it out, a little bit of moisture there so probably lucky I did before it turned to mold.

then fixed some water leaks  on the TL50.... its never ending in the shed.....

[Andreweasty90]

Cleaned up the bike looks ready to get dirty again


Sent from my iPhone using Tapatalk

[Barry G]

Shortened the "Lowline" brand steel roof rack that I picked up at auction for $85 last week.
Removed one 'ladder step' from each end, so it will fit length ways across the CT.
Will also still be long enough to use on separate mounts on the roof of the Jackaroo. 

[Andreweasty90]

Made a start on the bench tops for the new work bench


Sent from my iPhone using Tapatalk

[jmorgan1981]

Made a fridge slide/box for the pajero (box so I can stack stuff on top).
Total cost so far about $230. I still need to grab a couple of bolts, some tie downs and carpet to cover it.
A slide alone was going to cost me $340 plus.

[speewa158]

New season service for the ride on mower . Straightened the bent bits , had cans  ,  changed the oil  & filter , had cans, air filter , had cans , blades , had cans . Cant seem to remember what l did after that . But it works . Amazing 

[GGV8Cruza]

New season service for the ride on mower . Straightened the bent bits , had cans  ,  changed the oil  & filter , had cans, air filter , had cans , blades , had cans . Cant seem to remember what l did after that . But it works . Amazing 

Hope you filled it with oil and not the green can mixture

GG

[Pirate_Pete]

Started running blue spaghetti around the house as after 3 months arguing with Telstra that I can get ADSL at my house as the house across the road can I now have descent internet . . .

Then this week I get told that wireless NBN is now available  . . . .

When I was looking at the start of that 3 month process it wasn't even flagged as being set up in my area . . . . 

[GGV8Cruza]

Emptied it, 3 trailer loads are in the new one stacked on the floor ready for some organizational skills to tidy it up

GG

[D4D]

Emptied it, 3 trailer loads are in the new one stacked on the floor ready for some organizational skills to tidy it up

You know the drill

[GGV8Cruza]

You know the drill

Will add some when I get a chance, maybe after the move tomorrow and a spa soak in the evening

GG

[Coolblue80]

Got home at 5.30 this arvo. Checked the packing job the wife has done on the camper. Told her if anything has been forgotten, it's on her head. Put  the second battery back in the cruiser and checked charging voltages. Put the brides Pajero up on jack stands and took the front brakes apart. I will drop the rotors of tomorrow to get machined(not that the need it) but I'm throwing new Bendix 4wd pads in when we get back. The last pads I went against my usual brand and put in QFM pads. Don't like them at all. Barely 1/4 worn and they are coming out. Then I reversed the Cruiser up to the shed & pug the fridge back into 240v to continue cooling. Off for 4 nights in the morning for some R&R.
Cheers, Mike.

[msw]

Finally finished re-wiring the camper before our trip to Kevington.  Not sure I can fit anymore in...

[Crisp Image]

Well I fitted a heat exchanger under the bonnet of the tug so we can have hot water on the road for showers.
This was done to try and get happy life via the happy wife method.
It took me about 4 hours to get it in there and there is still some tidying up to do but I will wait for the final part to arrive but it will work on the weekend camping trip.
If anyone would like to join us then we are heading north of Licola.
Regards
Crispy

[xcvator]

I thought about finishing my new camper cover  , but then thought, why do today what I can put off till tomorrow 

[speewa158]

Finished off another batch of trains for market tomorrow & a few  Quality control , you understand 

[scarps]

Finished off another batch of trains for market tomorrow & a few  Quality control , you understand 

which market?


It's a Narvara STX V6 TD 3.0L

[speewa158]

Nagambie Farmers Market  from 8.30 till 1.30  1st Sat of each month . Extra special offer today only Driving lights in packet , never used ,  going cheap  ( to some )     Pre loved Hella Bull lights 100W lts all happening here