Shuflo pump

Started by Pingu, February 22, 2014, 09:54:43 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Pingu

Hi guys
We have a Shuflo 12v pump model number 4009 and it won't shut off after you've turned the tap off, can the shutoff pressure be adjusted?
Thanks in advance
Brian
Nissan Navara D40 - Jayco Penguin outback

darrenh

Pressure switch could be broken or you have a small leak some where


Sent from my iPad using Tapatalk HD
2006 100 series sahara
2008  Jayco flamingo outback

Malcolm Tugless

Quote from: Pingu on February 22, 2014, 09:54:43 AM
Hi guys
We have a Shuflo 12v pump model number 4009 and it won't shut off after you've turned the tap off, can the shutoff pressure be adjusted?
Thanks in advance
Brian
There is an adjustment screw on the front, but the manufacturers recommendation is not to touch it.

From what you've explained, it sound more likely that the micro-switch has failed. These can be replaced, but sometimes its cheaper to replace the whole pump.

Does the front of the pump look something like this:



If so, Caravan and RV World has this full upper housing assembly for $64.94.

Heres the link:
http://www.caravanandrvworld.com.au/plumbing-and-bathroom/pumps-and-accessories/shurflo-upper-assembly-4009-model

Assuming that it is the micro-switch. Another option is to remove the micro-switch and take it to an irrigation/pump joint. They may be able to supply just the switch at a fraction of the price others do.

Good luck.

Herks

Most probably you have some sand or grit in the pump valve stopping it closing.
Carefully remove the screws at the top, outside ones and under you will see small round disks about the size of a 2 cent pieces. Remove any sand grit etc. and carefully put it back together . Should now work. Take your time and don't force anything, there are rubber seals around the edge and will come apart with a small amount of effort.
Ta
John
Dmax Duel Cab LSU. Canopy, duel batteries, GVM Upgrade, Light Bar, Draw system, Fridge slide and much more. Avan Aspire Pop Top van, Many mods, 12v, 240v.

SteveandViv

I'd say the switch is gone. They tend to not pump at all if there is grit in the rubber seals inside. Even then it is like micros surgery to get it all out. I've had to a few times until I wised up and bought the surflo inlet filter, what a brainiack  i am  ;D
http://steveandviv.blogspot.com.au/

Diesel Power

Quote from: Herks on February 22, 2014, 03:27:56 PM
Most probably you have some sand or grit in the pump valve stopping it closing.
Carefully remove the screws at the top, outside ones and under you will see small round disks about the size of a 2 cent pieces. Remove any sand grit etc. and carefully put it back together . Should now work. Take your time and don't force anything, there are rubber seals around the edge and will come apart with a small amount of effort.
Ta
John

So what's a two cent piece?
Regards
Work - dedicated or medicated?

1999 HZJ105 GXL Auto Fully kitted. SOLD.
2008 VDJ200 GXL Auto.
2007 Custom built soft floor. SOLD.
2015 Kimberley Karavan Classic. SOLD.
2012 Kimberley Kamper Limited Edition.

solarpanel4

 

  Should you be in Victoria,try :-  www.awardrv.com.au/index.php
  Then check out "plumbing",new pumps, then hit download pdf
  New pumps quite cheap.Online ordering or pick up.
 


  good luck      Jeff

Pingu

Thanks for all the replies Ill let you know how i get on 
Nissan Navara D40 - Jayco Penguin outback