Used Conveyor Belt rubber - where to get

[MarkVS]

I am after some used conveyor belt rubber to put on my car/camper for an upcoming trip..I have been looking on the web and am finding it hard to get any.

Does anyone know where you can get 2nd hand conveyor belts in Brisbane


MarkVS

[AlanB]

Have a look for a belt splicing company as they normally work with conveyor belts and sometimes have some old belts, or they may put you in contact with a place that does.

[terravista]

Could go for a little drive to Toowoomba.

http://www.rubberbeltmart.com.au/

Cheers

[lino6]

A lot of the local quarries around here sell off the used stuff. Perhaps you could look up one of your locals and see if they have any?

[weeds]

how much do you need?

have access to 450 and 600mm width...........only cause you are a northsider

[cm4x4nut]

Mark, does colour matter and what size were you after?

[McGirr]

Mark, does colour matter and what size were you after?

L plate Yellow colour 

mark

[cm4x4nut]

L plate Yellow colour 

mark

Hahahaha, I only asked because I may be able to get some whiteish stuff from work.

But I like your response better..........

[MarkVS]

Thanks for your help everyone...

how much do you need?

have access to 450 and 600mm width...........only cause you are a northsider

PM sent..thanks.

Mark, does colour matter and what size were you after?

Craig, I think colour does matter when it comes to white..especially considering how dirty it will get. And you of all people know what happens when you mix White and dirt 

L plate Yellow colour 

mark

You'll keep.   

[Symon]

I got mine from the local rubbish tip - from memory it was about $6 for 4 metres.

[cm4x4nut]

Craig, I think colour does matter when it comes to white..especially considering how dirty it will get. And you of all people know what happens when you mix White and dirt 

Yeah, still cleaning the red out of different spots on the cruiser........lol

[duggie]

I have a roll on the top flat at my place.      It is a bit big to put in the mail though.

[weeds]

I managed to track some down for Mark


Sent from my iPad using Tapatalk

[GeoffA]

I managed to track some down for Mark


Sent from my iPad using Tapatalk

[99disco]

Just check the conveyer rubber out before you get carries away making you mud flaps, I used to use it but it's just to rigid and every time it hits the ground (curbs, speed bumps) it makes a hell of a bang coz there's no flex. I've since changed to rubber about 6mm thick, doesn't flap around to much but doesn't make a racket either.

Just a thought anyway.



Shane

[dungee]

how much do you need?

have access to 450 and 600mm width...........only cause you are a northsider

Ohhh, I'm a southsider.... any idea where I could get some from.  I used the 6mm rubber from Clarkes Rubber but it tore off in 6 months :-(