I am after some used conveyor belt rubber to put on my car/camper for an upcoming trip..I have been looking on the web and am finding it hard to get any.
Does anyone know where you can get 2nd hand conveyor belts in Brisbane ???
MarkVS
Have a look for a belt splicing company as they normally work with conveyor belts and sometimes have some old belts, or they may put you in contact with a place that does.
Could go for a little drive to Toowoomba.
http://www.rubberbeltmart.com.au/ (http://www.rubberbeltmart.com.au/)
Cheers
A lot of the local quarries around here sell off the used stuff. Perhaps you could look up one of your locals and see if they have any?
how much do you need?
have access to 450 and 600mm width...........only cause you are a northsider
Mark, does colour matter and what size were you after?
Quote from: cm4x4nut on February 06, 2014, 04:41:06 PM
Mark, does colour matter and what size were you after?
L plate Yellow colour ;D ;D
mark
Quote from: McGirr on February 06, 2014, 04:42:10 PM
L plate Yellow colour ;D ;D
mark
Hahahaha, I only asked because I may be able to get some whiteish stuff from work.
But I like your response better..........
Thanks for your help everyone...
Quote from: weeds on February 06, 2014, 12:18:16 PM
how much do you need?
have access to 450 and 600mm width...........only cause you are a northsider
PM sent..thanks.
Quote from: cm4x4nut on February 06, 2014, 04:41:06 PM
Mark, does colour matter and what size were you after?
Craig, I think colour does matter when it comes to white..especially considering how dirty it will get. And you of all people know what happens when you mix White and dirt ;D ;D
Quote from: McGirr on February 06, 2014, 04:42:10 PM
L plate Yellow colour ;D ;D
mark
You'll keep. >:D
I got mine from the local rubbish tip - from memory it was about $6 for 4 metres.
Quote from: MarkVS on February 06, 2014, 06:09:05 PM
Craig, I think colour does matter when it comes to white..especially considering how dirty it will get. And you of all people know what happens when you mix White and dirt ;D ;D
Yeah, still cleaning the red out of different spots on the cruiser........lol
I have a roll on the top flat at my place. ;D It is a bit big to put in the mail though.
I managed to track some down for Mark
Sent from my iPad using Tapatalk
Quote from: weeds on February 09, 2014, 12:44:17 PM
I managed to track some down for Mark
Sent from my iPad using Tapatalk
:cup: :cup:
Just check the conveyer rubber out before you get carries away making you mud flaps, I used to use it but it's just to rigid and every time it hits the ground (curbs, speed bumps) it makes a hell of a bang coz there's no flex. I've since changed to rubber about 6mm thick, doesn't flap around to much but doesn't make a racket either.
Just a thought anyway.
Shane
Quote from: weeds on February 06, 2014, 12:18:16 PM
how much do you need?
have access to 450 and 600mm width...........only cause you are a northsider
Ohhh, I'm a southsider.... any idea where I could get some from. I used the 6mm rubber from Clarkes Rubber but it tore off in 6 months :-(