We looked at the first release at the Brisbane show, Given it was a first put together and a bit rushed, Wondering if the few finish assembly quality issues have been addressed in the production runs ..
Internal mounted fittings [ TV mount and something in a cabinet screwed on with screws that were too long and deformed [ pimpling ] the big flat outer wall skins on both external side walls .. didnt look good ..
Rough ally welds to bunk bed frames .
Roof hatch Ally flat bar pivot to me needs to be a bit more beef to stop sideways movement ... The soft Automotive rubber roof seal is being chaffed / pinched and cut open at some point ..
We didnt mind it, but its a lot of coin for an ACP clad camper .
It was roomy enough for a bloke my size and the wife with mobility issues liked the lower entry step setup and the fact the bed was lower than level with the windows, unlike a lot of others we looked at.
Have the Gal dippers stopped blowing holes willy nilly in the chassis sections with an oxy on these new production runs