Just looking for some advice. I hooked up an ARB compressor on the weekend and it starts but then stops after about 5 secs.
I worked it out that its the part that the air hose connects to on top. I bought an air hose from ARB. It's seems the air is blocked from coming out. I took the part for the air hose off and it goes no problem. I put it back on and it cuts out.
I looked at the air hose connection and there is no opening for the air to come through.
Before I go to ARB I was wondering if any one else has had the same problem.
Mark
Not sure how the work, but mine has to be connected to a tyre for it to run.
It turns on at the switch, primes, then turns off (standby) until you connect it to tyres.
You mean it runs until the pressure switch turns it off? That's pretty normal.
Once you connect it to a tyre it should start running again.
Yep.
Thanks :cup:
Mark
Oh my. ???
So I'm not the only Clark Kent hiding a hot blonde under their quirky facade. :P
Sounds like it's buggered..............................give it to me ;D
Quote from: Symon on January 20, 2014, 05:24:20 AM
You mean it runs until the pressure switch turns it off? That's pretty normal.
Once you connect it to a tyre it should start running again.
I knew that, and now J.K knows that I know that. ;D
Mark
Quote from: McGirr on January 20, 2014, 11:19:05 AM
I knew that, and now J.K knows that I know that. ;D
Mark
Now that JK and I know, we'll never let you forget it ;D
Quote from: Symon on January 20, 2014, 11:23:40 AM
Now that JK and I know, we'll never let you forget it ;D
Dont I know that ;D ;D ;D
Mark
I can remove this thread if you like Mark, or I could make it a sticky ;D
GG
Quote from: GGPatrol on January 20, 2014, 11:41:42 AM
I can remove this thread if you like Mark, or I could make it a sticky ;D
GG
Making it a sticky would be better ;D