MySwag.org The Off-road Camper Trailer Forum
General => General Discussion => Topic started by: Cruiser 105Tvan on May 09, 2018, 11:35:18 AM
-
Anyone have the Fitting Instructions for fitting a Milford Barrier into a 105 Toyota S/wag. pls.
And yes I have searched.
-
Try emailing Milford direct.
-
Stop looking.
Thanks to another Forum, I have found them.
http://www.milford-auto.com/fitting_instructions/606925.pdf (http://www.milford-auto.com/fitting_instructions/606925.pdf)
-
When I installed mine, I used a step drill which made it very easy.
-
Thanks Wilsurf,
I'm curious as to whether a Rivnut/Nutsert would substitute for the Mounting plates Milford provide?
If anyone out there has run it past an Engineer?
It would make things so much easier.
TFA.